Wednesday, 8 March 2017

Shaft grave helmet: shaping

I made a core for the shaft grave helmet in much the same way as I did for the Phaistos helmet, except that this one has the leather strips tied around a bundle of horse hair.  This version went together much easier than the Phaistos one, because now I have a better idea of what I'm doing.  Notice how the bundle of strips at the top is sewn together?  The strips have holes in them and there's a length of strong linen thread twined through the holes.  This is important.  Just tying the leather strips together like a bundle of sticks doesn't work very well because the thread is inclined to slide upwards and pop off the top, and then you're back to square one.  Only the outer ring of strips need to be sewn; they keep all the other strips in place.

See how those strips are sewn together?

Now it's time for me to make the leather shell.  The curved padding around the bottom of this helmet will be made from leather stuffed with linen.  These pieces are simply long strips that have been shaped to form curved ridges.  As I've discussed before on this blog, veg-tanned armour leather can be soaked in hot water and then moulded.

In this photo the pieces have been soaked, curved, and stretched.  But as you can see, they're still not quite the right shape.  The edges don't curve inward all that well.  Even when softened, there's a limit to how much armour leather will stretch.

These edges don't curve nicely.

The solution is to notch the leather the way you would notch a curved seam on a garment.  I've cut small notches along the edges of the pieces, then soaked and shaped them again.  Now they fit around the helmet base much better.

These edges do curve nicely, even at the top where the curve is fairly steep.

I found it's important to cut the notches from the wrong side of the leather.  That way they end up being slightly smaller on the right side, and when you soak and shape them again they'll close up nicely.

Notice how the notches are a little wider on the inside than on the outside.  The notches should not be large - these are about 7mm long by 3mm wide.

Next time: assembling the helmet shell.


  1. Interesting! I have a question though. On what basis did you decide to go with the leather-stuffed-with-linen method instead of the wool felt you used the last time?

    1. Good question! This one will have the same wool felt components as the last one, but it will have linen stuffing in addition. I decided to use linen because there is evidence of linen armour from Mycenae. Schliemann found a piece of laminated linen when he excavated the shaft graves. Frustratingly, though not surprisingly, it was too fragmentary to tell exactly what it was and I couldn't find any information on how the layers were held together. It'll be interesting to see how it goes in a helmet.